Installers who specialise in Lift and safety communication, using PSTN, GSM, VoIP and Legacy wiring.
Liftcom Installation Ltd is a Henley-on-Thames based team fitting, testing and maintaining emergency communication equipment in lifts — autodiallers, intercoms, EVC systems and disabled toilet alarms. Able to set up EN81-28 Test calls and management.
- Works with PSTN, GSM and VoIP lines
- Fits equipment from all major UK lift suppliers
- Installed and tested to BS EN 81-28
- Full handover documentation on every job
Equipment we install
From the motor room to the car panel, we fit and commission every part of the communication chain — new installations, upgrades, and equipment swapped in for a lift contractor who's moved on.
CAR PANEL
In car alarm & Speaker box
Passenger facing vandal resistant speaker box assembly flush mounted with the existing car operating panel.
CAR PANEL
Surface mounted speaker box
For quicker installation a surface mounted speaker box assembly is used.
CONTROLLER
Autodialler mounted in the Lift Controller housing.
Keypad-configured units that log faults and connectivity status, so issues get picked up before a passenger reports them.
MOTOR ROOM
Autodialler interface with GSM unit
Existing or new installation of Autodialler interfaced with GSM gateway in anticipation of BT Switch Off.
SHAFT
Shaft & Lift Pit Outstations
Call points fitted in the lift shaft and Lift Pit for the safety of Engineers as required by EN81.
CAR TOP
Car top Intercom unit
Rugged intercom Outstation installed on top of car for Engineers safety.
EVC PANEL
EVC Emergency Call Point
Installation of Emergency Voice Communication (EVC) systems are specialised communication networks facilitating communication during emergencies. Aligned with BS 5839-9.
LIFT EVACUATION
Fire fighting -Evacuation Intercoms
Fire-fighting intercoms compliant with EN 81-72 and evacuation intercoms compliant with EN 81-76 can be installed. Surface-mounted units are suited to existing buildings, while flush-mounted units are ideal for new builds. The final interface with the lift controller is carried out by the lift maintenance company.
HANDOVER
Final full function test and Handover
Prior to installation, the lift is tested and the installation commenced. Once the installation is complete, the site is cleared and the system is fully tested in the presence of the customer. All relevant documentation is then handed over to the customer.
How we work
The same five steps on every job, whether it's one lift or a whole portfolio - a single engineer as a point of contact will be appointed.
Survey & quote
Depending on the service required, we may be able to provide an estimate. However, a detailed quotation will require a site visit.
Install
On arrival, the lift is fully tested prior to installation. Equipment can then be installed throughout the lift system, from the motor room and lift car down to the lift pit. Our engineers work around the building's access requirements, including out-of-hours working where necessary, to ensure minimal disruption.
Test & commission
After installation and site clearance, the system is fully tested and demonstrated to the customer's satisfaction.
Handover documentation
A complete record of what has been installed, including system settings and test results, is handed over to you or your lift contractor.
Ongoing support
Once the job is complete, our support doesn't end there. We will guide you through SIM selection and, more importantly, provide advice on meeting the EN 81-28 automated test requirements, along with ongoing support for any other questions you may have.
A small team, based in Henley-on-Thames
Liftcom Installation Ltd was set up to do one thing well: fit and maintain lift communication equipment properly, with the kind of personal service a small company can give and a large contractor often can't.
- We're happy to liaise with your existing lift maintenance contractor rather than replace them.
- Diagnostic and fault-finding service on systems we did not install can be carried out and a full report supplied.
- Every job leaves you with documents of exactly what was installed, its set parameters and test confirmation.
Get a straightforward quote for your lift's communication system.
Tell us what's on site now and what it needs to comply — we'll come back with a clear price, not a sales call.